Concrete cylinder piers
Concrete cylinder piers are precast concrete tubes stacked vertically beneath a foundation, driven or set to bear on deeper, stable soil. They are a common underpinning method for sinking or settling slabs and footings.
Concrete cylinder piers are precast concrete sections, usually round and about a foot or so across, that are stacked one on top of another under a foundation. Each stack is driven or hydraulically pushed down until it reaches firmer soil or bedrock, then the foundation is lifted or held on top of it. The result is a structural column that carries the load past the weak soil near the surface.
The method is a form of underpinning. Instead of patching cracks or leveling the house in place, the foundation gets a new bearing point at depth. That distinction matters because it addresses why the foundation moved in the first place: the soil under it could not hold the weight.
In Texas, the technique shows up most often on slab-on-grade homes built over expansive clay. Soils in and around Austin swell when wet and shrink when dry, and that movement can pull a slab out of level over time. Installers use cylinder piers as a way to reach past the active clay layer to a more stable stratum, and the pier stacks are typically tied to the slab with brackets or underpinning brackets so the house rests on them directly.
Because the piers are manufactured in standard sizes and installed with hydraulic equipment, the process is more predictable on residential jobs than many older methods. The piers themselves are inert concrete, and their performance depends on how deep they reach and how the load is transferred to them. Homeowners often encounter the term when comparing foundation repair proposals, so it helps to know it describes a specific structural approach, not a general repair.
If you are looking for firms that install this type of underpinning in the Austin area, the slab foundation repair providers in this directory are a good starting point.
"